China Pumping Solutions Leader
In the use of heat carrier furnace, it is necessary to check, measure, clean and record the equipment related to heat carrier furnace and hot oil pump, so as to understand the state of use of heat carrier furnace. Today, SAIKEN Pump industry will explain the work of high temperature heat conduction oil pump before and after use.
1. Cleaning of heat carrier furnace
1. The heating furnace room should maintain good lighting conditions.
2, do a good job of cleaning and sanitation of the heat carrier furnace room, high temperature heat conduction oil pump should do not accumulate debris in the furnace room.
3, to maintain the appearance of the heat carrier furnace and equipment cleanliness, high temperature heat conduction oil pump to remove the external ash, so that not only can create a clean and sanitary environment for the high temperature hot oil pump, but also easier to observe the operating state of the equipment, and can find the hidden dangers of the equipment.
4. The dust collector and the ash box should be cleaned, and the general high temperature hot oil pump should be cleaned two to three times per shift.
5, oil and gas furnace should often wipe the oil and ash on the combustion surface, high temperature hot oil pump, especially the vertical gas furnace, the top of the high temperature, it is prohibited to place some flammable goods.
Two, high temperature heat conduction oil pump inspection work
1. Check the use of the high temperature hot oil pump and the temperature of the heat conduction oil in the high groove. It is strictly prohibited to exceed 70℃, so as to prevent coking and leakage.
2, the furnace of coal heating furnace should not appear fire and suction phenomenon. Furnace high temperature heat conduction gear oil pump steel structure, masonry and furnace door should be intact, always keep the furnace tightness.
3, the high temperature heat conduction oil pump body and coal furnace furnace, grate and its ancillary equipment for tour inspection, to find the problems in time, and to take the corresponding measures.
4, check whether the pressure gauge, temperature meter and flowmeter of the furnace is in normal value, so as to judge the running state of the boiler.
5, check the operation of all equipment, transmission should be no noise. The lubricating oil should be sufficient before the deceleration of the coal machine hoist in the speed regulating box of the coal grate. The slag machine and the induced draft fan should be filled with lubricating oil, and the cooling water of the induced draft fan should be connected.
Three, high temperature heat conduction oil pump lubrication
To the lubrication points for regular refueling, so as to ensure the normal operation of the operating equipment.
Four, high temperature heat conduction oil pump recording work
The data obtained in the inspection (pressure, pressure difference, temperature, temperature difference) as well as the problems found must be recorded to provide a basis for future fault judgment and treatment.
